Saify Paint House

Berger NU Putty

Berger NU Putty

Berger NU Putty is a ready-to-use interior putty for cement, concrete, chipboard, and plywood. Berger describes it as a high quality putty that forms a smooth base for water-based paints.

Get Price on WhatsApp

Category:

Berger NU Putty — Ready-to-Use Interior Wall Putty in Karachi

Berger NU Putty is an interior wall putty from Berger Paints. Available at Saify Paint House, an official Berger Paints stockist in DHA Karachi, it is used to prepare the walls of a room before water-based paint goes on.

Berger describes it as a ready-to-use, high quality putty for interior use only. According to Berger, it forms an ideal base for a smooth finish with water-based paints, and it should not be used on exterior surfaces.

Why Putty an Interior Wall

Walls rarely finish perfectly flat. Small cracks, pinholes, and trowel marks show through paint, especially under a sheen finish. A putty fills these before painting, so the finished wall looks even.

Berger’s guidance is that the putty dries quickly enough to keep a job moving. It can be overcoated with finishing paint after 16 hours, so the work can go on the next day.

Key Features

  • Ready to use — Berger describes it as a ready-to-use putty
  • Interior use only — Berger says it should not be used on exterior surfaces
  • Smooth base for water-based paints — Berger’s description of the result
  • Designed for cement, concrete, chipboard, and plywood — Berger’s list of surfaces
  • Surface dries within 2 hours — Berger’s figure under normal conditions
  • Ready for finishing paint after 16 hours — Berger’s figure
  • Coverage of 5 to 7 m² per kg per coat — Berger’s figure

Recommended Applications

  • Interior cement and plaster walls
  • Concrete surfaces indoors
  • Chipboard and plywood surfaces indoors
  • Interior walls being prepared for water-based emulsion

Surface Preparation & Application

Berger says the surface must be completely dry and free from grease, dirt, and dust before you apply the putty. Use sandpaper or scrapers to prepare it, as Berger advises.

On previously painted walls, Berger recommends scraping off all old paint that is loose or flaking. Then apply a thin coat of Berger Plastron Primer before you put on the putty, for a better finish.

Berger also recommends a thin coat of Berger Plastron Primer under the putty if the finish will be Berger VIP Super Gloss Enamel or Berger All-Rounder Matt Enamel. Follow the pack for the application method and coat count.

Common Mistakes With Wall Putty

The most common mistake is putty over a wall that is not dry. Moisture trapped under the putty can cause it to bubble or lift. Check the wall, and treat any damp before you start.

Skipping the preparation is another. Dust, grease, and loose paint stop the putty from bonding, and the problem carries through to the paint. Scrape and sand first, then brush the surface clean.

Painting too early is a third. Berger gives 16 hours before finishing paint goes on, so keep to that time rather than rushing the next coat.

Care, Storage & Safety

Berger advises keeping the container protected from extreme hot or cold temperatures. Close the lid properly after use, and keep the pack upright. Keep it out of reach of children, avoid contact with eyes and skin, and rinse with clean water if contact occurs.

Choosing Between Berger Wall Putties

Saify Paint House stocks several Berger wall putties. NU Putty is the ready-to-use interior putty for cement, concrete, chipboard, and plywood. For another interior putty, ask our team about the options on the Berger range. For exterior walls, ask about Berger WeatherPro Exterior Putty or Berger Weathercoat Exterior Putty, since NU Putty is not for outdoor use. For primers under the putty, ask about Berger Plastron Wall Primer. Visit our Berger Paints range to compare them.

Where damp or seepage is present, treat the cause before filling and painting. See our Ressichem building care and waterproofing range.

Planning Your Project

Measure the wall area and use Berger’s coverage figure of 5 to 7 m² per kg per coat to estimate how much putty you need. Berger sells it in 5 kg and 20 kg packs. Allow for two coats on rough or uneven walls. Our team can work out the quantity with you, along with the primer and paint.

Buy Berger NU Putty in Karachi

Berger NU Putty is available through Saify Paint House at two DHA Karachi locations: Shop #2, Plot 31-E, 7th Street, Badar Commercial, DHA Phase 5, and Shop #2, Al Raheem Center, Main Gizri, opposite Mubarak Masjid.

For pricing, pack sizes, and availability, message us on WhatsApp or call 0333-5843610.

Get Price on WhatsApp

Scroll to Top